http://dev.forums.reprap.org/list.php?30 Sat, 21 Nov 2009 04:40:26 -0800 Phorum 5.2.11 http://dev.forums.reprap.org/read.php?30,29508,29508#msg-29508 http://dev.forums.reprap.org/read.php?30,29508,29508#msg-29508
The Australian RepRap groups seem to be losing a bit of momentum lately, I think this may be due to the lack of parts here in Oz.

I have looked at sourcing all the metal parts from the U.S and am inquiring to see how many people would be interested in a kit.

The kit contains:

1 brass nozzle with a 0.4mm orifice
1 brass heater barrel
1 PTFE thermal break
1 steel drive screw
2 brass half-bearings for the drive screw
2 nuts for the steel drive screw

I am currently waiting for the pricing to bring in a bulk lot and will let anyone interested know

Please reply if your interested.]]> Oscar Fox Australia, Sydney RUG Tue, 03 Nov 2009 21:19:58 -0800 http://dev.forums.reprap.org/read.php?30,8115,8115#msg-8115 http://dev.forums.reprap.org/read.php?30,8115,8115#msg-8115 I have come to the point where the cost is getting to much.
and making some of the bits is too hard for me.

therefore will sell it all to someone one that has more time and more money then i do.

I have 3 * 0.9 steppers motors
have the Ex-head plus some spares
have all the electronics controller boards(5)most built and tested, stop ends, pic's and others bits..


make an offer and we can go from there.

BarryGlen]]> BarryGlen Australia, Sydney RUG Mon, 26 May 2008 15:38:00 -0700 http://dev.forums.reprap.org/read.php?30,6195,6195#msg-6195 http://dev.forums.reprap.org/read.php?30,6195,6195#msg-6195
I just saw this forum but I have been follow the development Reprap since the beginning. I am looking forward to meet any like mind to start building Reprap - please contact me if you are interested.

:)-D]]> phon xay Australia, Sydney RUG Thu, 12 Nov 2009 16:44:21 -0800